With regard to lift stations, the challenges for operators take several different forms. By way of priority, it is important to carry out the collection and transfer of effluents while also avoiding discharge into the natural environment.
Next, as with any facility involved in the collection and purification of waste water, the operators must comply with regulatory requirements related to self-monitoring. SOFREL solutions meet this dual requirement in a simple and effective manner.

Monitoring lift stations

Through continuous analysis of tank water level and pump operation, the remote terminal unit performs a set of calculations concerning volumes and flowrates passing through the facility: incoming flow, pump flow, volume pumped by the station, day/night ratio, etc.

Pump flowrates are calculated using a self-adaptive method tried and tested in the field. Operators can therefore anticipate issues of pump clogging or wear and make use of this tool for preventive maintenance. Tracking the day/night rate enables evaluation of parasitic water infiltration into the network.

Pumping process control

Effective pump management requires more than simple pump permutation on each start-up. In reality, there are a significant number of criteria to be considered: the number of pumps authorised to operate in parallel, the maximum running time for each pump, the time between a stoppage and start-up, pump and sensor fault management, etc.
All these parameters are clearly accessible in the remote terminal unit settings and are therefore easily adaptable to each specific case or type of lift station.
Additional functions such as excess flow management enable operators to reconcile the demands of service continuity and compliance with the hydraulic constraints of the network. As such, the remote terminal unit can provide full process control for the lift station and facilitate greater energy efficiency.

Lift station remote control